Installation items of UHMWPE polyethylene silo lining board

1. (1) During the installation process, the bolt countersunk head plane of Ultra high molecular weight polyethylene bin liner (coal bin liner) must be lower than the plate surface;

(2) No less than 10 bolts shall be used per square meter for installation of Ultra high molecular weight polyethylene lining board (coal bunker lining board);

(3) The gap between each Ultra high molecular weight polyethylene bin lining board (UHMWPE coal bin lining board) plate shall not be greater than 0.5cm(it shall be adjusted appropriately according to the environmental temperature of the plate during installation).

2. The gap between each Ultra high molecular weight polyethylene bin lining board (coal bin lining board) plate shall not be greater than 0.5cm(it shall be adjusted appropriately according to the environmental temperature of the plate during installation).

The fixed form of the UHMWPE polyethylene silo liner (coal silo liner) must take into account its free expansion or contraction in the case of a large change in operation or ambient temperature. Any fixation method should be designed to facilitate the flow of bulk material and the screw head is always embedded in the liner. For thicker lining, the edge should be cut into 45 degrees. In this way, the length is allowed to change and a smooth plastic plane is formed in the silo, which is conducive to the flow of materials.

ABOSN is engaged in the production of Ultra-high molecular weight polyethylene liner according to many years, can be customized according to the bin use demand production, if you need to understand the actual use of the case, please call to consult!